Lean-Systems Attachments
Tape, Ball & Stone Superfinishing
     
Advantages of Supfina attachments:
• Band finishing machines:
Change-over from band to stone finishing possible; dry finishing possible
• Pneumatic finishing machines:
Robust and low-cost allround machines, low small space requirements
• Mechanical finishing machines:
Impressively smooth run properties, parameter stability even at varying loads
• Spherical finishing machines:
High-precision finishing of flat and spherical surfaces
     
     
  Attachment 110  
 
For workpieces of 10-100mm Ø and 1000mm length, with outrigger also for holes of 30 Ø up to 120mm in depth. Appropriate attachments also allow flat finishing.For the finishing of transmission shafts, side shafts, drive and driven shafts, balancing shafts, bearing seats or ring seal seats on shafts.  
         
  Attachment 200      
    For small- to middle- sized work pieces, Ø 10 – 100 mm and length around 1500mm. Also possible is ID and flat finishing. Variable oscillation amplitude makes this unit well suited for working against a shoulder.
  
         
  Attachment 210      
    For smaller and medium-sized workpieces, plunge or traverse finishing. Also for the small series, single piece, production runs or repair.  
     
  (Subject to technical modifications)